[Setup] Error: Couldn't install: zope.interface 3.6.3

Nathan Van Gheem vangheem at gmail.com
Sun Jun 3 21:37:58 UTC 2012


What buildout are you running?

Can you try running ./bin/buildout -vv

to see what error you are getting in detail?

On Sun, Jun 3, 2012 at 1:09 PM, Aaron Rothenberg
<a_rothenberg at hotmail.com> wrote:
> Thanks Nathan
>
> I do have the latest python-dev installation
>
> as per your suggestion, I used python-brew to install 2.6 and 2.6.6. I used
> both versions to  bootstrap.(then /bin/buildout)
>
> I still get the same error and I still don't  have anything new in bin( I
> was expecting at least "test" and "coverage").
>
> I may try and re-install Ubuntu 11.04 and go with that. Might that help?
>
> Thanks again.
>
>
>
>> Date: Sun, 3 Jun 2012 00:42:06 -0500
>> Subject: Re: [Setup] Error: Couldn't install: zope.interface 3.6.3
>> From: vangheem at gmail.com
>> To: a_rothenberg at hotmail.com
>> CC: plone-setup at lists.plone.org
>
>>
>> Do you have the python development package installed?
>>
>> sudo apt-get install python-dev
>>
>> If you're doing a buildout of plone 4.1, python 2.6 is what is
>> supported for that version.
>>
>>
>> Good luck,
>> Nathan
>>
>> On Sat, Jun 2, 2012 at 10:47 PM, Aaron Rothenberg
>> <a_rothenberg at hotmail.com> wrote:
>> > I'm using  Martin Aspeli's chapter3 bootstrap and buildout
>> > from Professional
>> > Plone 4
>> > Development.
>> >
>> > I'm in Ubuntu 12.04 and I'm using python 2.7.2 (if that matters). This
>> > machine is dedicated to this project so I 'm free to do
>> >  anything necessary
>> > to resolve this.
>> >
>> > The error is after I run bin/buildout from a  myPloneProject folder.
>> >
>> > the Bin created after the bootstrap  only has 1 buildout item
>> > ("buildout")
>> > in myPloneProject  after the failed bin/buildout.
>> >
>> > here is the output-
>> > Getting distribution for 'zope.interface==3.6.3'.
>> > error: None
>> > An error occured when trying to install zope.interface 3.6.3. Look above
>> > this message for any errors that were output by easy_install.
>> > While:
>> >   Installing.
>> >   Getting section instance.
>> >   Initializing section instance.
>> >   Installing recipe plone.recipe.zope2instance.
>> >   Getting distribution for 'zope.interface==3.6.3'.
>> > Error: Couldn't install: zope.interface 3.6.3
>> > *************** PICKED VERSIONS ****************
>> > [versions]
>> >
>> > *************** /PICKED VERSIONS ***************
>> >
>> > note: I have 2 decades in  development almost all in .net (some lamp)
>> > but
>> > I'm pretty new to python, eggs, buildouts...
>> >
>> > Thanks.
>> >
>> >
>> >
>> > _______________________________________________
>> > Setup mailing list
>> > Setup at lists.plone.org
>> > https://lists.plone.org/mailman/listinfo/plone-setup
>> >
>
> _______________________________________________
> Setup mailing list
> Setup at lists.plone.org
> https://lists.plone.org/mailman/listinfo/plone-setup
>


More information about the Setup mailing list