[Setup] UnifiedInstaller: not automatically start after boot of PC

[ieyasu]

Rui, thank you!

I think I've solved the problem.
The followings are the procedures.

I first copied /opt/Plone-3.1/zinstance/bin/zopectl to /etc/init.d/.

Next, I installed "sysv-rc-conf" on my ubuntu because ubuntu 
doesn't have "chkconfig".

Last, I did the following.
# sysv-rc-conf --level 016 zopectl off
# sysv-rc-conf --level 2345 zopectl on
# sysv-rc-conf --list


rfernandes wrote:
> 
> Hi
> 
> I don't use ubuntu but you can check this documentation page
> https://help.ubuntu.com/community/UbuntuBootupHowto  on "Installing custom
> init-scripts" section.
> 
> good luck,
> Rui
> 
> 
> ieyasu wrote:
>> 
>> Hi,
>> 
>> I'm using Ubuntu 8.04.
>> 
>> (1) I downloaded Plone-3.1.2-UnifiedInstaller
>> (2) I did "./install.sh standalone", which was successful.
>> (3) Then, I did "/opt/Plone-3.1/zinstance/bin/instance start", which was
>> also successful.
>> 
>> But when I boot PC, it seems neither Zope or Plone starts...
>> I have to "instance start" manually again...
>> 
>> Should I do something other than (1)-(3) in order for Plone to start
>> everytime my PC restarts?
>> 
>> 
>> 
> 
> 

-- 
View this message in context: http://www.nabble.com/UnifiedInstaller%3A-not-automatically-start-after-boot-of-PC-tp17716593s15482p17863472.html
Sent from the Installation, Setup, Upgrades mailing list archive at Nabble.com.